Table of Contents
Terms in this set (5) What advice does the author of “How to Jump-Start a Car Battery” give for connecting the jumper cables to the battery? Don’t start the car as you’re connecting the cables.
How do you jumpstart a car battery quizlet?
Terms in this set (10)
- Put the red clamp on the positive terminal on the car with the dead battery.
- Put the red clamp on the postive terminal on the car with the good battery.
- Put the black clamp on the negative terminal on the car with the good battery.
What are the 5 steps to jumpstart a car?
5 Steps to Jumpstart your Car!
- Start the engine with a working battery. Turn on the engine of a working car and pull it close to the vehicle with the dead battery.
- Connect the batteries with jumper cables.
- Start the car.
- Carefully disconnect two batteries.
- Inspect the condition of the cables after the jumpstart.
What gear should a car be in when jump start?
The most common way to push start a vehicle is to put the manual transmission in second gear, switching the ignition to on/run, depressing the clutch, and pushing the vehicle until it is at a speed of 5 to 10 mph (8 to 16 km/h) or more, then quickly engaging the clutch to make the engine rotate and start while keeping …
When jump starting a car always remember negative?
The positive (red) cable should be attached to the positive terminals on each battery. The negative (black) cable should have one end attached to the negative terminal of the dead battery, and one end grounded.
What is the correct order to connect jumper cables?
The safest order to attach the jumper cables is as follows:
- Attach one red jumper cable clamp to the positive terminal on the dead battery.
- Attach the other end of the same cable, the second red jumper cable clamp, to the positive terminal on the working (live) car battery.
How long should I jump my car for?
As a rule of thumb, it’s good to wait about two minutes with the car running, letting the power flow through. Then, after two minutes, try and start your car to see if it starts working.
What’s the best way to jump start a car?
This is the last connection you need to make. Start the car with the charged battery. Wait one or two minutes and try to start the car with the dead battery. Remove the black negative clamp from the ground of the vehicle needing the jump.
How do you jump start a dead battery?
Connect a positive cable clamp to the positive (+) terminal of the dead battery. Connect the other positive cable clamp to the positive (+) terminal of the charged battery. Connect a negative cable clamp to the negative (-) terminal of the charged battery.
What’s the best way to start a car battery?
Pull the car close enough so that the cables will easily reach from the battery of one car to the battery of the other. Shut off both engines and prop open the hoods or trunks, depending on where the batteries are located within the vehicles. Find the batteries and their terminals.
What’s the difference between positive and negative jumper cables?
There are also positive and negative cables in the jumper cable set. The red one is positive (+), the black one is negative (-). Never connect the red cable to the negative battery terminal or a vehicle with a dead battery. Identify a metal ground within the vehicle with the dead battery. You can use the metal frame of the vehicle.