Table of Contents
How do I reset my Jandy salt cell?
Each time a flow sensor is unplugged and plugged back in again the computer inside the unit must be reset by turning the power ‘off’ and then ‘on’.
What is AquaPure?
AquaPure is safe, economical, and environmentally friendly way to purifying your pool and spa. The AquaLink RS displays salt levels, allows for adjustments to purifier production levels, and monitors water temperatures daily while the AquaPure system is purifying your pool. Complete control – with a touch of a button.
How do you clean a Jandy flow sensor?
Turn the flow/temp/salinity sensor counterclockwise to remove it from the three-port cell. Clean the sensor contacts gently with a household cleaning pad. Rinse well with water. This should be done yearly.
How do you turn off Jandy AquaPure?
Press the salinity button and hold it for 5 seconds. The unit will beep when it is pressed and then again after 5 seconds, this will silence the alarm for 24 hours or until the unit is turned off and on again. Turn the AquaPure off by pressing the A (down arrow) and setting CHLORINE PRODUCTION to 00%.
How do you know when to replace your salt cell?
What Are Some Signs That Your Salt Cell May Need Replacing?
- Looking worse for wear, it’s lost a few plates and the acid baths just aren’t working.
- Your pool is starting to turn green or cloudy, even though your chlorinator is turned up to 100%.
How do I know if my chlorine generator is working?
The first step is to confirm that power is reaching the salt chlorinator control box. Make sure that the system is plugged into a GFI outlet, and the test button is not popped or tripped. The control panel has lights that indicate that the power is reaching the system.
How long should SALT cells last?
This is all possible thanks to your pool’s salt chlorine generator cell. With proper care, a cell will last about five years. Eventually, though, it will need to be replaced.
Where do I find the service code on my aquapure?
A service code is a three digit number that appears on the display panel of an AquaPure Control Box, letting you know if your AquaPure unit is experiencing any problems. Service codes are fast, easy to read, and not only identify the problem, but direct you to an available solution.
What does a service code on a Jandy aquapure mean?
If you have a Jandy AquaPure 700 or 1400 chlorinator, there’s a chance you may have come across a service code (or error code) before. A service code is a three digit number that appears on the display panel of an AquaPure Control Box, letting you know if your AquaPure unit is experiencing any problems.
Which is Aqualink RS is controlling the aquapure?
AquaLink RS is controlling the AquaPure and desired output percentages. AquaLink RS is controlling the AquaPure and “Boost” is active.
What is the water temp in Jandy aquapure boost mode?
Temperature of Pool is < 50ºF (10°C). Chlorine production stopped. In “Boost” mode unit will operate at 100% production for 24 run time hours. Input has exceeded Maximum Range. AquaLink RS is controlling the AquaPure and desired output percentages.